ISLA Instruments S2400 User Manual
– 49 –
Live Loop Settings
Press Shift+Pad to display the Live Loop settings and functions for each Live Loop.
Output
The output that the loop will play through.
Divisions
A Live Loop can be the full length of the pattern (one division), or it can be a fraction of the
pattern length. For example, if divisions is set to two, then the Live Loop will be half the length
of the pattern, and will play twice each time the pattern plays through.
Rec. Mode
Record mode can be:
Latched: Press and release a pad to record, press and release it again to stop recording.
Momentary: Press and hold a pad to record, release it to stop recording.
Fixed Length: The Live Loop will be the length of the pattern. After pressing the pad, it will start
recording at the beginning of the pattern, and stop recording at the end. It can also be stopped
short by pressing the pad before the end has been reached.
Mute/Solo
Mute and solo buttons can take effect immediately, or at the beginning of the pattern. Pending
mute/solo actions are indicated by a blinking mute/solo button.
Gain
Sets the base gain for the Live Loop. The gain setting is combined with the level fader when the
loop is played.
Filter Mode
Each Live Loop has its own filter, and each one can be either low pass, band pass, or high pass.
To Next Page
Loading...