6A-58 ENGINE MECHANICAL (C22NE, 22LE, 20LE)
5. Apply a bead of sealant (TB-1207C or equivalent) in the
grooves of both bearing shells
Important!
After installation of bearing cover, press in sealing compound
again from above, until compound emerges at the joints.
Torque - Angle Method
Bearing cover to cylinder block - 50 N⋅m (5.1 kgf⋅m) +40° to 50°
Con-rod bearing cover to con-rod - 35 N⋅m (3.5 kgf⋅m) +45° to
60°
Use new botls.
6. Install oil pump, oil pan, rear crankshaft sealing,
flywheel/drive plate, and aggregates according to the
corresponding operations.
Inspection
Bearing play - bearing cover removed
Measure
With "Plastigage" (ductile plastic threads)
Cut threads to length of bearing width and lay axiaity between
crankshaft journal and bearing shell (arrowed).
Install bearing cover with correct torque.
Important!
Grease crankshaft journal and lubricate bearing shell slightly so
that the thread does not tear when the bearing cover is moved
Crankshaft
Inspection
End play when bearing shells are installed.
Front end contact surfaces of flywheel/flexible plate.
Permissible end play - see "Technical Data "
To Next Page
Loading...
