ITech IT6000D Series

Basic Operation
Category Parameter Initial Value
• IO–4: Ext-Trig
• IO–5: INH-Living
• IO–6: Sync-On
• IO–7: Sync-Off
Parallel Single
Config
menu
Mode CV
Speed High
V-Rise Time/I-Rise Time 0.1s
V-Fall Time/I-Fall Time
Output Res 1000
On Delay/Off Delay 0
Protect
menu
OVP/OCP/OPP/UCP/UVP Sta-
tus switch
Off
OVP/OCP/OPP Protection point:
Level
Rated voltage / current /
power value of the
instrument
UCP/UVP Protection point:
Level
0
OVP/OCP/OPP/UCP/UVP Delay
time: Delay
60s
UCP/UVP Warm time: Warm-up
5.14 View the System Information (System Info)
This menu item is used to view the system information of the instrument.
The procedures to view the system information are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the System Info and press
[Enter].
Copyright © Itech Electronic Co., Ltd.
120