ITech IT6000D Series

To Next Page

To Previous Page

Inspection and Installation

3U Slave Models

2.4 Connecting the Power Cord

Precautions

To prevent electric shock and damage to the instrument, observe the following

precautions.

Main Page

Warranty3
Limitation of Warranty3
Safety Symbols4
Safety Precautions4
Environmental Conditions6
Regulation Tag7
Waste Electrical and Electronic Equipment (WEEE) Directive8
Compliance Information9
Table of Contents10
Quick Reference12
Brief Introduction12
Front-Panel Overview14
Keyboard Introduction15
Push-On Knob17
Rear Panel Introduction18
VFD Indicator Lamps Description19
Configuration Menu Function20
System Menu Function22
Options Introduction27
Inspection and Installation29
Unpacking and Transportation29
Verifying the Shipment32
Instrument Size Introduction33
Connecting the Power Cord34
Connecting the Device under Test (DUT)40
Remote Interface Connection46
USB Interface46
LAN Interface47
CAN Interface52
GPIB Interface (Optional)53
Interface (Optional)54
Getting Started57
Power-On Self-Test57
Set Output Value61
Use the Front Panel Menu62
On/Off Control63
Power Supply Function64
Set the Output Voltage64
Set the Output Current64
Set the Output Power65
Config Menu for Power Supply65
Set the CC/CV Priority Mode65
Set the Internal Resistance68
Set the Output-On/Output-Off Delay68
Protection Function for Power Supply68
Set Over-Voltage Protection (OVP)72
Set Over-Current Protection (OCP)72
Set Over-Power Protection (OPP)73
Set Under-Current Protection (UCP)74
Set Under-Voltage Protection (UVP)75
Over-Temperature Protection (OTP)76
Sense Reverse Protection76
Function Menu for Power Supply77
LIST Function77
Battery Charging Test Function88
Basic Operation91
Local/Remote Mode Switch91
Key Lock Function91
Save and Recall Operations92
Save Operation93
Recall Operation93
Data Logging Function93
Set the Beeper Status (Beep)96
Set the Power-On State (Poweron)97
Sense Function (Sense)98
Select Trigger Source (Trig Source)99
Set the Communication Information (I/O Con)100
Set Parallel Operation Mode (Parallel)101
Digital I/O Function (Digital Port)105
IO-1. Ps-Clear, Not-Invert109
IO-2. Ps, Not-Invert111
IO-3. Off-Status, Not-Invert112
IO-4. Ext-Trig, Not-Invert114
IO-5. INH-Living, Not-Invert117
IO-6. Sync-On, Not-Invert120
IO-7. Sync-Off, Not-Invert122
Analogue Function (Ext-Program) (Optional)124
Restored to Factory Setting (System Reset)129
View the System Information (System Info)131
System Upgrade132
Technical Specification136
Main Specification136
126137
It6005D-80-150137
It6010D-80-300139
It6015D-80-450141
132143
It6006D-300-75143
It6012D-300-150145
It6018D-300-225147
138149
It6006D-500-40149
It6012D-500-80151
It6018D-500-120154
145156
It6006D-800-25156
It6012D-800-50158
It6018D-800-75160
1500V162
It6018D-1500-40162
2250V164
It6018D-2250-25164
Supplemental Characteristics167
Routine Maintenance168
Instrument Self-Test168
Cleaning and Maintenance168
Contact of ITECH Engineers169
Return for Repair170
A Appendix172
Specifications of Red and Black Test Cables172
Troubleshooting173
Fuse Replacement175

Table of Contents

Related product manuals