Inspection and Installation
• Before connecting power cord, be sure to confirm that the power
voltage matches with the rated input voltage of the instrument.
• Before connecting power cord, be sure to switch off the instrument.
Verify that there is no dangerous voltage on the connection
terminals.
• To avoid fire or electric shock, make sure to use the power cord
supplied by ITECH.
• Be sure to connect the power cord to the AC distribution box with
protective grounding. Do not use terminal board without protective
grounding.
• Do not use an extended power cord without protective grounding,
otherwise the protection function will fail.
• Ensure that the power cord connection terminals are either insu-
lated or covered by the supplied protective cover so that no acci-
dental contact with lethal voltage can occur.
Safety agency requirements dictate that there must be a way to
physically disconnect the AC mains cable from the unit. A dis-
connect device, either a switch or circuit breaker must be pro-
vided in the final installation. The disconnect device must be
close to the equipment, be easily accessible, and be marked as
the disconnect device for this equipment.
Categories of Power Cords
The standard power cord specifications for this series of 3U instruments are div-
ided into the following types according to different regions:
Copyright © Itech Electronic Co., Ltd.
24
To Next Page
Loading...
Need help?
General
