Getting Started
Precautions
• Before connecting power cord, be sure to confirm that the power
voltage matches with the supply voltage.
• Before connecting power cord, be sure to switch off the instrument.
Verify that there is no dangerous voltage on the terminals before
touching them.
• To avoid fire or electric shock, make sure to use the power cord
supplied by ITECH.
• Be sure to connect the main power socket to the power outlet with
protective grounding. Do not use terminal board without protective
grounding.
• Do not use an extended power cord without protective grounding,
otherwise the protection function will fail.
• Ensure that the input electrodes are either insulated or covered us-
ing the safety covers provided, so that no accidental contact with
lethal voltages can occur.
• If you notice strange sounds, unusual odors, fire, or smoke around
or from inside the instrument, flip the POWER switch to the (O) side
to turn the instrument off, or remove the power cord plug from the
outlet. The detachable power cord may be used as an emergency
disconnecting device. Removing the power cord will disconnect
AC input power to the unit.
Power Switch Introduction
User can adjust the power switch directly to turn on or turn off the instrument.
The status of Power switch is as follows.
On Off On Off
If the instrument is the cabinet type, the rear panel of the cabinet provides a
master power switch. The relationships between the device status and switch
status are listed in the following table.
Copyright © Itech Electronic Co., Ltd.
47
To Next Page
Loading...
Need help?
General
