ITech IT6512D - Calibrate:monitor:current:level; Calibrate:monitor:current[:Data]; Calibrate:program:voltage:level

Calibration Command
Copyright© Itech Electronics Co., Ltd. 99
Command syntax
CALibrate:MONitor:VOLTage[:DATA] <NRf>
Arguments
NRf
Unit
V
Example
CAL:MON:VOLT 30.0V
CALibrate:MONitor:CURRent:LEVel
This command is used to set monitoring the current calibration point.
Command syntax
CALibrate:MONitor:CURRent:LEVel <P0|P1>
Arguments
P0|P1
Example
CAL:MON:CURR:LEV P0
CALibrate:MONitor:CURRent[:DATA]
This command is used to current calibration point data for monitoring.
Command syntax
CALibrate:MONitor:CURRent[:DATA] <NRf>
Arguments
NRf
Unit
A
Example
CAL:MON:CURR 15.0
CALibrate:PROGram:VOLTage:LEVel
This command is used to set voltage calibration point for programming.
Command syntax
CALibrate:PROGram:VOLTage:LEVel <P0|P1>