ITech IT6512D - Chapter9 Load Related Command（It6500 C; Load[:State]; Load:selection

Load Related Command（IT6500C）
Copyright© Itech Electronics Co., Ltd. 50
Chapter9 Load Related Command（IT6500C）
Except LOAD[:STATe] command, other commands are specially for IT6500C,
which are not suitable for IT6500D series models.
LOAD[:STATe]
This command is used to set load state. When the load of IT6500C Series
power supply is on, you need to select internal load or external load. Default
load is internal load. IT6500D Series power supply only has internal load. This
command is used to turn on and off load function state.
Command syntax
LOAD[:STATe] <bool>
Arguments
0|1|OFF|ON
Reset Value
OFF
Example
LOAD 0
Query syntax
LOAD[:STATe]?
Returns
0|1
LOAD:SELection
This command is used to select internal load or external load, which is
applicable for IT6500C Series power supply.
Command syntax
LOAD:SELection <INTernal|EXTernal>
Arguments
INTernal|EXTernal
Reset Value
INTernal
Example
LOAD:SELection INT