ITech IT6512D - Status:operation[:Event]; Status:operation:condition; Status:operation:enable

SCPI Command Description
Copyright© Itech Electronics Co., Ltd. 14
Query syntax
STATus:QUEStionable:NTRansition?
Returns
NR1
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register.
After executing this order, operation event register is reset.
Query syntax
STATus:OPERation[:EVENt]?
Arguments
None
Returns
<NR1>
Related Command
STATus:OPERation:ENABle
STATus:OPERation:CONDition?
This command can read the parameter from the operation condition register.
When the parameter of operation condition register changes, the bit
corresponding in operation event register is 1.
Query syntax
STATus:OPERation:CONDition?
Arguments
None
Returns
<NR1>
STATus:OPERation:ENABle
This command can set the parameter of operation event enable register.
Setting parameter can determine which bit value of operation event register is 1
and the bit will cause OPER of status byte register to be 1.
Command syntax
STATus:OPERation:ENABle <NR1>
Arguments
0～65535