ITech IT6512D - Carwave:sae[:Test]:2 B[:State]; Carwave:sae[:Test]:2 B:voltage[:Level]; Carwave:sae[:Test]:2 B[:Time]:Td[:Level]

Car Wave Command（IT6500C）
Copyright© Itech Electronics Co., Ltd. 79
CARWave:SAE[:TEST]:2B[:STATe]
This command is used to simulate the SAEJ1113-11 TEST 2B.
Command syntax
CARWave:SAE:2B <bool>
Arguments
ON|OFF|1|0
Reset Value
0
Example
CARWave:SAE:2B 1
Query syntax
CARWave:SAE:2B?
Returns
0|1
CARWave:SAE[:TEST]:2B:VOLTage[:LEVel]
This command is used to select voltage system of SAEJ1113-11 TEST 2B.
Command syntax
CARWave:SAE:2B:VOLT <12V|24V>
Arguments
12V|24V
Reset Value
12V
Example
CARWave:SAE:2B:VOLT 12V
Query syntax
CARWave:SAE:2B:VOLT?
Returns
<CRD>
CARWave:SAE[:TEST]:2B[:TIMe]:TD[:LEVel]
This command is used to set pulse width of SAEJ1113-11 TEST 2B