Display Commands
Copyright ©ITECH Electronic Co., Ltd. 20
Chapter4 Display Commands
DISPlay
This order is used to turn on/off the VFD display. When the display is off, the
output and will not be displayed on the VFD, at the same time, all the LED
except for ERROR led will not be off. When the control mode is local, the
display will turn on automatically, press LOCAL button can switch the control
mode from remote to local.
Order syntax:
DISPlay[:WINDow][:STATe] <bool>
Parameter:
0|1|OFF|ON
Example:
DISPlay 1
Quest syntax:
DISPlay?
Returned parameter:
0|1
DISPlay:TEXT < Reference value>
This order is used to display a text on the VFD. TA message can display up
to 12 characters, extra characters will be ignored. Commas, periods and
semicolons will not be treated as a separate character but will be
contained to the character before and display.
Order syntax:
DISPlay[:WINDow]:TEXT[:DTAT]
Quest syntax:
DISPlay:TEXT?
DISPlay:TEXT:CLEar
This order is used to clear the text displayed on the front panel.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
