ITech IT6942A - Remote Operation Mode; RS232 Interface Configuration

Current Control Commands
Copyright ©ITECH Electronic Co., Ltd. 28
[SOURce:]CURRent:PROTection:TRIPed?
This command is used to query the execution status of overcurrent protection.
If "1" is returned, it indicates that the overcurrent protection circuit is triggered
and the OCP status is not cleared. If "0" is returned, the OCP circuit is not
triggered.
Order syntax:
[SOURce:]CURRent:PROTection:TRIPed?
Return parameters:
0|1
[SOURce:]CURRent:PROTection:CLEar
This command is used to clear the overcurrent protection status. After
executing this command, the output current will return to the output state before
the OCP protection occurs and the upper limit current value of the OCP
overcurrent protection will remain at the previously set value. Please note that
the external factor causing overcurrent protection should be excluded before
sending this command.
Order syntax:
[SOURce:]CURRent:PROTection:CLEar
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com