ITech IT6942A - Current:step; Current:trig{<Current Value>|Minimum|Maximum

Current Control Commands
Copyright ©ITECH Electronic Co., Ltd. 26
CURRent:STEP
This order is used to service for CURR UP and CURR DOWN two orders. It can
set the stepping value of current. Besides, CURR:STEP? DEF order can
inquire the stepping resolution of current of this unit. For example, he stepping
setting value is 0.01,it represents 10mA.
Order syntax:
[SOURce:]CURRent[:LEVel][:IMMediate]:STEP[:INCRement] <NRf>
Parameters:
MIN~MAX
*RST value:
the stepping resolution of current of this unit.
Query order:
CURRent:STEP?
Return parameters:
<NR2>
CURRent:TRIG{<current value>|MINimum|MAXimum}
This order is used to set a current to be triggered. At first, this current value is
saved and only when receiving a trigger signal will the power supply output with
this current value. Sending order CURRent will not affect the setting value in
this order. Sending query order, unit will return the previous setting value. If
customer does not utilize order CURRent:TRIG at the beginning, then the
return parameters will be the value you set with order CURRent. CURR:TRIG?
MAX or CURR:TRIG? MIN orders will let you know the max and min current
you can set.
Order syntax:
[SOURce:]CURRent[:LEVel]:TRIGgered[:IMMediate][:INCRement] <NRf>
Parameters:
MIN to MAX
Unit:
A
Query syntax:
CURRent:TRIG? [MINimum|MAXimum]
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com