Control Commands
Copyright ©ITECH Electronic Co., Ltd. 33
Chapter9 Control Commands
APPLy {<voltage value>|DEF|MIN|MAX} [,{<current
value>|DEF|MIN|MAX}]
This order has combined two kinds of orders: VOLTage and CURRent. When
sending this order to unit, power supply will output voltage and current
according to the current setting of this order. Of course the precondition is the
setting value is within the set range. If not, then a execution error will occur. You
can also use DEF, MIN or MAX as the setting parameters.DEF represents
factory setting. MIN will enable the voltage and current to be 0. MAX will enable
the output to be the highest value in the range.
Order syntax:
[SOURce:]APPLy <NRf>
Parameters:
MIN to MAX
Unit:
V, A
Query syntax:
APPLy?
Return parameters:
<NR2>
ADDR
Address matching commands for multi-machine mode. When the command is
sent, the power supply with the same address as that set by the command is
connected to the PC, and the related operations of the power supply can be
performed on the PC.
Order syntax:
ADDR <NR1>
Parameters:
0 to 30
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
