Voltage Control Commands
Copyright ©ITECH Electronic Co., Ltd. 30
VOLTage:STEP {<value>|DEFault}
This order is used to service for VOLT UP and VOLT DOWN two orders. It can
set the stepping value of voltage. Besides, VOLT:STEP? DEF order can inquire
the stepping resolution of voltage of this unit. For example, the stepping setting
value is 0.01, it represents 10mV.
Order syntax:
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement] <NRf>
Parameters:
MIN~MAX
*RST value:
the stepping resolution of voltage of this unit
Query order:
VOLT:STEP?
Return parameters:
<NR2>
VOLT:TRIG{<volts>|MINimum|MAXimum}
This order is used to set a voltage to be triggered. At first, this voltage value is
saved and only when receiving a trigger signal will the power supply output with
this voltage value. Sending order VOLTage will not affect the setting value in
this order. Sending query order, unit will return the previous setting value. If
customer does not utilize order VOLT:TRIG at the beginning, then the return
parameters will be the value you set with order CURRent . CURR:TRIG? MAX
or CURR:TRIG? MIN orders will let you know the max and min voltage you can
set.
Order syntax:
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude] <NRf>
Parameters:
MIN to MAX
Unit:
V
Query syntax:
VOLT:TRIG? [MINimum|MAXimum]
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
