List Commands
Copyright ©ITECH Electronic Co., Ltd. 37
Chapter11 List Commands
LIST:FUNCtion
This order is used to select the state of list mode.
Order syntax:
[SOURce:]LIST:FUNCtion<0|1>
Query syntax:
[SOURce:]LIST:FUNCtion?
Return parameters:
0|1
LIST:STEP
This command is used to set the total number of steps (1~100) of the List.
Order syntax:
LIST:STEP <NR1>
Query syntax:
LIST:STEP?
Return parameters:
NR1
LIST:VOLTage
This order is used to set the steps of list file and voltage of current step.
Order syntax:
[SOURce:]LIST:VOLTage <NRf>
Parameters:
MIN~MAX
Unit:
V
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
