ITRON 100W-R User Manual

Initializing, Programming, and Connecting the ERT Module
TDC-0951-005 100W-R and 100WP-R Datalogging ERT Module Installation Guide 8
Proprietary and Confidential
Programming the 100WP-R
Programming the 100WP-R requires one of the following handheld computers running Field Deployment
Manager (FDM) version 1.0 or later.
 FC200SR handheld computer (Itron part number FC2-0005-004 or FC2-0006-004)
 FC300 with SRead
For normal activation, connect the 100WP-R to the water meter register and program the ERT module with
FDM.
100WP-R Pulser Start-up
The 100WP-R enters run mode by completing programming with FDM. Programming sets the appropriate
pulser parameters (initial consumption and Utility ID).
Itron strongly recommends performing a Check ERT with a handheld computer running FDM to verify the
100WP-R is operating correctly after installation. Performing a Check ERT will:
 Generate an immediate register read.
 Align the 100WP-R's time with the handheld's time.
Important Periodically dock or cradle the handheld computer or mobile reader to keep the time current.
 Verify communication with the Leak Sensor.
 Check for tamper flags.

ITRON 100W-R Specifications

General

Brand	ITRON
Model	100W-R
Category	Control Unit
Language	English