ITRON ERT 40W User Manual

Installing 40W and 50W ERT Modules PUB-0126-001 4/04
01547b
2-3
Push the gel connectors down into
the ERT module housing
here.
Place the
ERT module in the slot of the
bracket.
The
edge of the ERT module housing
should be against the ribbed side in
the slot.
NOTE: A gasket is not required.
2-4
2-5
Install the mounting screws as
shown. Hand tighten each screw.
Obtain four Torx-head
ERT module mount-
ing screws.
2-2

ITRON ERT 40W Specifications

General

Brand	ITRON
Model	ERT 40W
Category	Control Unit
Language	English