ITRON ERT 40W - SECTION 4. INSTALLING THE SCHLUMBERGER ARB V OR PROREAD REGISTER-MOUNT; Register Preparation and ERT Module Selection

Installing 40W and 50W ERT Modules
01342z
01672
01547z
4-1
4-2
Pull the bottom edge of the
wire terminal enclosure cover
out and down as shown .
Obtain a 40W or 50W Schlumberger
ARB V ERT module if connecting to an
ARB V register.
Obtain a 40W or 50W Schlumberger
ProRead ERT module if connecting to
a ProRead register.
SECTION 4. INSTALLING THE SCHLUMBERGER ARB V OR PROREAD
REGISTER-MOUNT
Check the part number on the label to make sure the ERT module matches the meter (reference
Table 1-1).
Always install an ERT module right side up, as indicated by the on the label.
CAUTION: If an ERT module is dropped from a height of 3 feet or more, there may be damage to
the circuit board. DO NOT install the ERT module.
NOTE: Schlumberger's ProRead register must be programmed with a Schlumberger
ProRead Programmer as 3-wire to work properly with the ERT. Schlumberger ARB V registers
are not programmable.
Schlumberger ARB V Register
(ProRead is similar)
UP
4-1