ITS Telecom Pancode - Resetting Unit to Default Settings; PanCam-T and Pantel Setup

PanCam/Pantel/Pancode Installation and Programming Manual 13
3.3 Resetting the PanCam/Pantel/Pancode
Resetting the PanCam/Pantel/Pan code will automatically
change the parameters in the unit to the manufacturers default.
To Reset the Unit
1. Enter programming mode (see section 3.2, Entering
Programming Mode ).
2. Dial *151.
3. A confirmation tone will be heard.
4. Exit programming mode.
To Reset the Unit in “speed dial” mode (only
PanCam - C and Pancode)
1. Enter programming mode (see section 3.2,
Entering Programming Mode ).
2. Dial *152.
3. A confirmation tone will be heard.
4. Exit programming mode.
3.4 PanCam - T/Pantel Setup and Operation
The following table contain s programming functions, which
can be accessed in the programming mode for Setup and
operation.
PBX Parameter Commands
OPERATION COMMAND DEFAULT
Day, Night
destination
numbers
*360 + X + DN + #
where:
X = 1; Day destination
X = 2; Night destination
DN = U p to 20 digits.
For special character
input, see section 3.6
Entering Special
Characters DTMF, on
page 21.
Day = 0
Night = 0
Delete the
destination
assignments
*360 + X + #
where:
X = 1; Day destination
X = 2; Night destination