ITS Telecom Pancode - Setting PanCam-C;Pancode Operation Mode; Standard Setup Configuration

PanCam/Pantel/Pancode Installation and Programming Manual 15
3.4.1 Selecting the Mode of Operation
To Set the PanCam - C/Pancode Operation Mode
1. Dial the PanCam - C/Panc ode line/extension from any
touch - tone telephone.
2. Wait until the PanCam - C/Pancode answers and
beeps.
3. Dial *900.
4. Enter the Programming Access Password (default
password is 1234.)
5. For Standard Mode, dial *151 (See 3.5.2 for
programming)
- or -
for Speed - Dial M ode, dial *152 (See 3.5.3 for
programming).
Note: After selecting the mode of operation by using *151 or
*152, the unit will reset to default values for
each mode.
3.4.2 Standard Setup
The following table contains programming functions, which
can be accessed i n the programming mode for Standard Setup
operation.
PBX Parameter Commands
OPERATION COMMAND DEFAULT
The Day/Night
DN will be
dialed when the
Call button
is pressed,
respective to
Day/Night
mode. The
Error DN is
dialed after
receiving three
invalid Acc ess
Code entries in
a row
*360 + X + DN + #
where:
X = 1 Day
X = 2 Night
X = 3 Error
Destination number (DN) =
Up to 20 digits, including
*,#, Pause, and A - D
characters. For special
character input, see section
3.6 Entering Special
Characters DTMF, on page
21.
Day = 0
Night = 0
Error =
No
default