ITS Telecom Pancode - PanCam-C Camera Operation Settings

Programming
20 PanCam/Pantel/Pancode Installation and Programming Manual
OPERATION COMMAND DEFAULT
Changing the
programming
password
*600 + (new password)
Programming access
passwords must be four
numeric digits. The
allowable characters are
0 through 9. Do not use
the * or # keys.
1234
*For PanCam -C
Camera
instructions
*620 + X
X = 0 camera always
off
X = 1 camera always on
X = 2 camera p owered
when call button is
pressed
X = 3 powered by any
touch on unit keypad
0
3.5 Entering Special Characters DTMF
Special characters can be entered using the keypad. The
following table shows the corresponding keypad entries
needed for DTMF of special chara cters.
DTMF CHAR. NUMBER TO DIAL
Digits 0 -9 0-9
* **
Pause *1, indicates a 1 second pause
# *4
A *5
B *6
C *7
D *8