ITS Telecom Pancode - Defining Remote Door Opening Digits

PanCam/Pantel/Pancode Installation and Programming Manual 19
OPERATION COMMAND DEFAULT
Delete a
destination
number assigned
to Day, Night, or
Error DNs. This
command must be
entered separately
for each X value
*360 + X + #
where:
X = 1 Day
X = 2 Night
X = 3 Erro r
For Pancode
Indoor only
*371
Defining the
digit(s) to open
the door from any
extension
*441 + XXXX + #
XXXX= Digits (0 - 9)
Note: Up to 4 digits
8
Changing the
Opening door
Access Code
*442 + 0XXX+#
0XXX = New Access
Code up to four digits.
The fi rst digit of the
access code in Speed-
dial mode must be 0.
If the new access code
is less than four
numeric digits, press the
# key following entry of
the digits. The
allowable characters are
0 through 9. Do not use
the * or # keys.
0123
Time between
DTMF ’s
*460 + X
where:
X = 1 -9
(each step is 200 msec)
400
Conversation time
limit (sec)
*462 + XX
XX = Seconds (10 - 99)
00 = Unlimited
45 sec
Door opening
time limit (sec)
*464 + X
XX = Number of
seconds (1 - 9)
3 sec