ITS Telecom Pancode - Assigning Speed-Dial Numbers; Assigning Day;Night;Error Destination Numbers

Programming
18 PanCam/Pantel/Pancode Installation and Programming Manual
PBX Parameter Commands
OPERATION COMMAND DEFAULT
Assigning a
Speed - dial
destination
number.
This command
must be entered
separately for
each X value
*120 + X + DN + #
X = a digit 1 through 9
DN = Destination
number (DN) = Up to
20 digits, includin g *, #,
Pause, and A - D
characters.
For special character
input, see section 3.6
Entering Special
Characters DTMF .
No default
Cancelling a
Speed - dial
destination
number.
This command
must be entered
separately for
each X value
*120 + X + #
X = a digit 1 through 9
No default
Assigning
Destination
Numbers (DN) to
Day, Night and
Error. This
command must be
entered separately
for each X value.
The Day/Night
DN will be dialed
when the Call
button is pressed,
respective to
Day/Night mode.
The Error DN is
dia led after
receiving three
invalid Access
Code entries in a
row
*360 + X + DN + #
where:
X = 1 Day
X = 2 Night
X = 3 Error
Destination number
(DN) = Up to 20 digits,
including *, #, Pause,
and A - D characters. For
special character input,
see section 3.6 Entering
Special Characters
DTMF .
Day = 0
Night = 0
Error =
No default