ITS Telecom Pancode - PanCam-C and Pancode Setup Modes

Programming
14 PanCam/Pantel/Pancode Installation and Programming Manual
OPERATION COMMAND DEFAULT
*For Pantel
Indoor ONLY:
Busy off/on time
cadence setups for
disconnecting the
line when the
destination is busy
*371 + X + YYYY
where:
X = 1; off time setup
X = 2; on time setup
YYYY = Cadence in
step of 20 milliseconds
500 msec
500 msec
Digit(s) to open
the door from any
exte nsion
*441 +XXXX + #
where:
XXXX = Digits (0 - 9)
Note: Up to 4 digits
8
Time between
DTMF’s
*460 + X
where:
X = 1 -9
(each step is 200 msec)
2 (400ms)
Maximum time
for the line to be
opened (sec)
*462 + XX
XX = Seconds (10 - 99)
00 = Unlimited
45 sec
Door o pening
time limit (sec)
*464 + X
X = Seconds (1 - 9)
3 sec
Change the
system
administrator’s
password
*600 + New password
(must be 4 digits).
Warning: Do not use *
or # keys
1234
*For PanCam -T
Camera
instructions
*620 + X
X = 0 camera always
off
X = 1 ca mera always on
X = 2 camera powered
when call button is
pressed
0
PanCam -C/Pancode Setup
The PanCam - C/Pancode can work in two modes of operation:
Standard and Speed -dial.
In Standard mode, which is the default, the keypad requires
direct dialing of exte nsions and numbers.
In Speed - Dial mode, keys 1 - 9 can be assigned destination
phone numbers. When a key is pressed, the assigned
destination number is dialed.