ITS Telecom Pancode - Changing Door Opening Access Code; Setting Door Opening Time Limit; Changing Programming Access Password

PanCam/Pantel/Pancode Installation and Programming Manual 17
OPERATION COMMAND DEFAULT
Changing the
Opening door
Access Code
*442 + (New Access Code)
Access Codes can be up to
four numeric digits. If the
New Access Code is less
than four numeric digits,
press the # following the
entry of the digits.
Allowable characters are 0
through 9. Do not use the *
or # keys.
Note : The access code
can not begin with the s ame
pre f ix digits as PBX
ex tension numbers
9876
Time between
DTMF’s
*460 + X
where:
X = 1 -9
(each step is 200 msec)
2 (400)
Conversation
time limit (sec)
*462 + XX
where:
XX = Seconds (10 - 99)
00 = Unlimited
45 sec
Door opening
time limit (sec)
*464 + X
where:
X= Number of seconds (1 - 9)
3 sec
Changing the
programming
password
*600 + (new password)
Programming access
password must be four
numeric digits. Allowable
characters are 0 through 9.
Do not use the * or # keys.
1234
*For
PanCam -C
Camera
instr uctions
*620 + X
X = 0 camera always off
X = 1 camera always on
X = 2 camera powered
when call button is pressed
0
3.4.3 Speed-Dial Setup
The following table contains programming functions, which
can be accessed in the programming mode for Speed - Dial
mode opera tion.