ITW Dynatec DynaFiber UFD - Recommended Service Parts List

ITW Dynatec
Chapter 8
Options & Accessories
Page 102 UFD Applicator, Manual 40-43, Rev. 6.16
Recommended Service Parts List
As a general rule, we recommend that you keep on hand:
• Heaters: half as many of each heater as listed on the BOM,
• Sensors: half as many of each sensor as listed on the BOM,
• Kits: half as many as the number of modules on the BOM,
• O-rings: the same quantity as listed on the BOM,
• Filter Baskets: twice as many as listed on the BOM.
Recommended quantities of spare parts vary depending on each individual applicator. Refer to your
Applicator’s bills of materials (BOMs) to determine quantities of heaters, sensors, O-rings, filter
baskets and kits.
Part Number Description
Qty. per
Applicator
105150
UFD Module Rebuild Kit
Ar required
803012
UFD Hi-Temp Module Rebuild Kit
Ar required
See ordering guide
Heaters
Ar required
See ordering guide
RTD Sensor, Service Block
1
See ordering guide
RTD Sensor, Preheater 1
N03812
O-ring #125
2
N00196
O-ring #111
1
N00181
O-ring #014
1
N00178
O-ring #011
Ar required
N00176
O-ring #009
Ar required
N00174
O-ring #007
Ar required
102645
High-Temp Splice Kit
1
See ordering guide
Filter Basket
2
001V061
Thermal Paste
1
See ordering guide
Solenoid Valve
1
See ordering guide
Nozzle
2