ITW Dynatec DynaFiber UFD - Filter Kits; Service Kits; High-Temp Splice Kit, PN102645; UFD Nozzle Cleaning Oven

ITW Dynatec
Chapter 8
Options & Accessories
Page 96 UFD Applicator, Manual 40-43, Rev. 6.16
Filter Kits
To simplify ordering, Filter Kits are available.
Filter Kit
Part Number
O-ring
Part Number
Filter Cap
Part Number
Filter
Part Number
114291
N03812 O-ring #125
106303
101247 100 mesh, Basket
124292 N03812 O-ring #125 106303 106273 150 mesh, Basket
116246*
N03812 O-ring #125
116244
116245 150 mesh, Spin-on
116595*
N03812 O-ring #125
116244
116593 200 mesh, Spin-on
* PN 116246 M-20 Spin-On Filter Assembly (filter code C),
PN 116595 M-20 Spin-On Filter Assembly (filter code D)
Service Kits
• UFD Module Rebuild Kit PN 105150 (codes H, V, HQ, VQ)
• UFD Module Rebuild Kit PN 110889 (codes K, F)
• UFD Hi-Temp Module Rebuild Kit PN 803012
The module rebuild kits contain all the parts necessary to rebuild one module.
High-Temp Splice Kit, PN102645
This kit consists of a foot of shrink-wrap tubing and nine connectors (splices). These parts plus a
sensor (order the sensor separately from the chart in this chapter) will enable you to replace the
sensor in one applicator.
UFD Nozzle Cleaning Oven
(PN 107307 = 200-240V Oven/ PN 107306 = 120V Oven)
The use of the UFD Nozzle Cleaning Oven eliminates the need to disassemble the UFD nozzles for
cleaning. Nozzles are baked in the oven for approximately six hours at 750-800 °F (400-425°C).
Complete cleaning instructions are provided with the oven.
Assembled view:
Filter
Filter cap PN 116244
Sealing washer
PN 116243
O-ring
PN
N03812
Filter Kit,
150 mesh PN 116245
200 mesh PN 116594