Chapter 7
Component Illustrations & Bills of Materials
UFD Applicator, Manual 40-43, Rev. 6.16 Page 53
Chapter 7
Component Illustrations & Bills of Materials
All parts must be periodically inspected and replaced if worn or broken. Failure to do this
can affect equipment’s operation and can result in personal injury.
This chapter contains the component illustrations (exploded-view drawings) for each
assembly. These drawings are useful for finding part numbers as well as for use when
maintaining or repairing the equipment.
Note: Most common nuts, bolts and fasteners can be obtained locally at your hardware
store. Specialty fasteners are available by contacting ITW Dynatec’s Customer Service.
To Next Page
Loading...