ITW Dynatec DynaFiber UFD - Air Preheater Assembly for 1- or 2-Port UFD Slim Design

ITW Dynatec
Chapter 7
Component Illustrations & Bills of Materials
Page 58 UFD Applicator, Manual 40-43, Rev. 6.16
Air Preheater Assembly for 1- or 2-Port UFD Slim Design
Module Option Codes C, G, J, M only,
(This slim design is available in four port PN 112793 and six port PN 112794 Assemblies)
Item No. Part Number Description Qty.
36
112791
Air Preheater Assembly Slim Design (DCL)
1
37 N00093 Fitting, Compression 1
38
N00174
O‐ring, ‐007
1
39
N00181
O‐ring, #‐014
2
40
109252
Screw M5x25mm
4
41
106726
Pin Dowel, M5 x16mm
2
42
Nozzel (see order for part number)
1
43 112690
Module, HHSB Vert., Direct Air (shown for ref. See your
order)
1- 2
44 078C088 Washer #4 int. Tooth 2
45
112714
Spiral Tube, Slim Design
2
46
112784
Preheater Manifold (1 port)
1
112785
Preheater Manifold (2 port)
1
47
112788
Wire Cover 1‐2 port (Part Of Cable Assy.)
1
48
Temperature Sensor (shown for ref. part of cable assy.)
1
49
106306
Spacer
2
50 101692 Screw M4x35mm 2
51
106329
Heater, Cart, 200w, 240v, 10 x 60mm (Part OfCable Assy.)
2
52
112806
Cable Assembly, DCL, Slim Line, 1 - 2 port
1
53 101627 Screw M3x6mm 2