ITW Dynatec DynaFiber UFD - Section 5, 24 VDC MAC Solenoid Valve, 4 Way, 1;4 NPT, PN 112496

ITW Dynatec
Chapter 10
Appendix
Page 110 UFD Applicator, Manual 40-43, Rev. 6.16
Section 5, 24 VDC MAC solenoid valve, 4 way, 1/4 NPT, PN 112496
Section 5
PN 113350
24 VDC Festo high speed solenoid valve, 4 way, 6mm inlet fitting,
2.5m cable
PN 113451
24 VDC Festo high speed solenoid valve, 4 way, 1/4 inlet fitting,
2.5m cable
PN 114558
24 VDC Festo high speed solenoid valve, 4 way, 6mm inlet fitting,
10m cable
PN 114559
24 VDC Festo high speed solenoid valve, 4 way, 1/4 inlet fitting,
10m cable
Description
Direct-acting spool valve, 4-way, 24 VDC operation with M7 ports. Solenoid is configured
to connect directly to the module. It is not setup for use as an in-line solenoid.
Connections
Port 1
Inlet
Port 2
Close side of module
Port 3
Exhaust
Port 4
Open side of module
Port 5
Exhaust
Typical Setup
Apply full air pressure (80-90 psi / 5.5-6.2 bar) to Port 1 of solenoid valve.
Tubing
Wiring Schematic
Pneumatic Schematic
Solenoid
Voltage: 24 VDC
Wattage: 6.5W max.
Solenoid valve supplied with Applicator.
Module PN 113346