ITW Dynatec DynaFiber UFD - Extension Cable Assemblies

Chapter 8
Options & Accessories
ITW Dynatec
UFD Applicator, Manual 40-43, Rev. 6.16 Page 99
Extension Cable Assemblies
The following extension cable assemblies are available. These cables connect one applicator zone to
the ASU. One cable assembly per applicator is usually required for the preheater; others may be used
as necessary for the installation.
Controller
Cable
Part Number
Cable
Length
Cable
Part Number
Cable
Length
DCL/ PLC
(control option D)
103773
10‘
103776
25‘
103774 15‘ 105123 30‘
103775
20‘
105147
40‘
MCV
(control option M)
084F222
10‘
084F682
25‘
084F225 15‘ 084F383 30‘
084F223
20‘
Upgrade (Ni RTD)
(control option N)
102706
10‘
105834
40‘
106349
25‘
Upgrade (J-type TC)
(control option L) Service
Block only
107044 2m 107047 8m
107045
4m
107309
10m
107046
6m
Upgrade (J-type TC)
(control option L)
Air Heater only
110149 2m 110152 8m
110150
4m
110153
10m
110151
6m
Upgrade (Pt RTD)
(control option P)
Service Block only
110159 2m 110162 8m
110160
4m
110163
10m
110161
6m
Upgrade (Pt RTD)
(control option P)
Air Heater only
110154
2m
110157
8m
110155 4m 110158 10m
110156
6m