37
5.2.7 Pausing the active program
– Press STOP once to pause a running program (green LED flashing). Press the STOP key twice to completely stop the
program or press START to continue.
– If the program is paused, the display shows a flashing "Pause" and the indicator changes back to the program screen.
– If a program is stopped prematurely, "Vacuum release" is shown in the display during the flooding of the firing
chamber.
5.2.8 Changing the parameters while the program is running
Most program parameters, which have not yet been executed, can be changed while the program is paused. Change the
parameters as described in Chapter 5.2.3.
5. Operation and Configuration
To Next Page
Loading...
