60
6. Practical Use
6.3 Press procedure using an Ivoclar Vivadent press program
Step 1:
Switch the furnace on.
Switch the furnace on using the mains switch at the back of the
furnace. Subsequently, the furnace conducts an automatic self-test.
Wait until the furnace has reached the pre-set stand-by temperature.
Step 2:
Select the operating mode.
After the self-test has been completed, the selection of the operating
modes is displayed. Select the operating mode "Pressing".
Step 4:
Select the desired investment ring size.
Depending on the program selected, up to three different
investment ring sizes can be chosen (100 g / 200 g / 300 g). Not all
programs can be run with all the investment ring sizes. Please also
refer to the Instructions for Use of the respective material.
Step 3:
Select the program.
Press the [Ivoclar Vivadent Programs] button.
Select the desired program.
To Next Page
Loading...
