57
6. Practical Use
The practical procedure of conducting a firing or a press cycle is explained by means of an Ivoclar Vivadent program and an
individual program.
6.1 Firing procedure with an Ivoclar Vivadent program
Step 1:
Switch the furnace on.
Switch the furnace on using the mains switch at the back of the
furnace. Subsequently, the furnace conducts an automatic self-test.
Wait until the furnace has reached the pre-set stand-by temperature.
Step 2:
Select the operating mode.
After the self-test has been completed, the selection of the operating
modes is displayed. Select the operating mode "Firing".
Select the desired program.
Step 3:
Select the program.
Press the [Ivoclar Vivadent Programs] button.
Select the desired program group.
To Next Page
Loading...
