63
6. Practical Use
6.5 Press procedure using an individual press program
Step 1:
Switch the furnace on.
Switch the furnace on using the mains switch at the back of the
furnace. Subsequently, the furnace conducts an automatic self-test.
Wait until the furnace has reached the pre-set stand-by temperature.
Step 2:
Select the operating mode.
After the self-test has been completed, the selection of the operating
modes is displayed. Select the operating mode "Pressing".
Step 4:
Select the desired investment ring size.
Three different investment ring sizes (100 g / 200 g / 300 g) are
available for the individual press programs.
Step 3:
Select the program.
After the self-test has been completed, the home screen appears on
the display. Press the [Individual Programs] button.
Select the desired program.
To Next Page
Loading...
