Settings
6 720 645 504 (2011/04) en
84
> Country
B Select country.
Here, a different country can be selected than was
chosen as part of the pre-configuration (start-up).
16.10 Alarms
The different alarms that can occur are described in
(Chapter 17).
Under Alarms there is:
• Alarm log
• Delete alarm log
• Alarm history
• Alarm indication
The alarm log shows the alarms and warnings that have
occurred. Alarm category ( Chapter 17.7) is displayed
in the top left corner of the display and if the alarm is
active, the alarm symbol is displayed both in the alarm
log and the initial menu of the control panel.
The alarm history saves complete information about the
latest 20 alarms/warnings. The most recent record is
listed first.
Press and turn the dial to see all information about
the alarm. Turn the dial to see more alarms.
The information shows the current values immediately
after the appearance of the alarm but before action/
cancellation.
16.10.1 Alarm indication
Settings for alarm buzzer and status lamp are made
here.
> Alarm buzzer signal
>> Interval
B Set the length of the alarm interval.
The alarm buzzer sounds for one second and is silent
during the rest of the interval. The setting applies to
all alarm buzzers.
>> Blocking time
B Indicate the times between which the alarm buzzer
may not give out a sound.
All alarm buzzers are silent during a set interval.
> Alarm indication control unit
>> Block alarm buzzer
The setting applies only to the control unit's alarm
buzzer.
> Alarm indication room sensor
>> Block alarm buzzer
B Set if the alarm buzzer should be off or not.
The setting applies to Circuit 1 and to a CANbus-
connected room sensor.
>> Block alarm indicator lamp
B Set if the indicator lamp should be off or not.
The setting is common for all room sensors.
> General alarm level
>> Alarms and warnings
No means that alarms produce a signal on the general
alarm output. Yes means that alarms as well as warnings
produce a signal on the general alarm output.
Factory setting 2s
Lowest value 2s
Highest value 3600s (60min)
Tab. 179 Interval
Factory setting Off
Start time 0:00 - 23:45
Stop time 0:00 - 23:45
Tab. 180 Blocking time
Factory setting No
Alternative No/Yes
Tab. 181 Block alarm buzzer
Factory setting Yes
Alternative No/Yes
Tab. 182 Block alarm buzzer
Factory setting Yes
Alternative No/Yes
Tab. 183 Block indicator lamp
Factory setting No
Alternative No/Yes
Tab. 184 Alarms and warnings
To Next Page
Loading...
Need help?
General
