Setup Interface:
The Setup interface allows users to set serial port baud rate, enable DHCP, reboot the device and
apply a factory reset.
Baud Rate Setting
4 Baud Rate Settings: 9600 | 19200 | 57600 | 115200 (default)
Example: Setting Baud Rate to 9600
Operation:
①Select “Setup” in the main menu and press the “ENTER” button
②Press the “Up and Down” buttons to select “Baud”
③Press “ENTER” to enter the next sub-menu
④Press the “Up and Down” buttons to select “9600”
⑤Press “ENTER” to apply the setting change
To Next Page
Loading...