J-Tech Digital JTD-669 - Web Interface Access; PC Network Configuration; Internet Protocol Settings

31 pages

To Next Page

To Previous Page

Web Control

Change IP Address of PC:

Before configuring the device through the web GUI, it is necessary to configure the IP address

of the computer connected to the JTECH-4KM44A (to ensure that the computer and the

device are set in the same network segment).

1).

Open Network Settings > Change Adapter Properties and set the computer's IP address

2).

Choose to use Static IP (Use the following IP address), with the IP address set to

196.168.1.x (x ranges from 0 to 254, excluding 168 [device’s default IP])

3).

Subnet mask set to 255.255.255.0

4).

Gateway set to 192.168.1.1