11
A triggered alarm in progress is indicated by a rapidly flashing red segment button and a backlit
indication button. You need to authorize yourself using the keypad in order to terminate the alarm.
The section remains set, a rapidly flashing red segment button indicates the alarm memory. Indication will
keep on flashing even after the system has been unset.
If the alarm memory indication was activated during your absence, search for the cause of the alarm
in the event history and be very careful when entering and checking the premises or wait until the security
agency arrives (provided your system is connected to an ARC).
The segment alarm memory indication remains on until the system is set once again. Alternatively, it can
be cancelled by unsetting the system one more time. Alarm indication can be also cancelled from the main
menu from the keypad with an LCD display – Cancel warning indication.
Indication of a triggered tamper alarm can be terminated only by a Service technician or Administrator.
Note: When using the “EN 50131-1, grade 2” system profile, it is always necessary to first authorize
yourself and then perform the desired action.
Terminating an alarm using a remote control will also unset the corresponding section.
2.1.2.6 SECTION CONTROL FROM THE MENU OF THE KEYPAD
WITH AN LCD DISPLAY
Statuses of sections are displayed in the left top part of the keypad’s LCD display. A fully set section
is shown by a number in a rectangle filled with black colour ; a partially set section is depicted
by a framed number 4 .
Control from the keypad menu:
a Authorization by a valid code or an RFID chip.
a Enter the menu by pressing ENTER.
a Section Control → ENTER.
a Select the desired section using arrows.
a Pressing ENTER repeatedly will change between section statuses partially
set / set / unset.
a Press ESC to exit the menu.
2. OPERATING THE JABLOTRON 100
+
SYSTEM
2
To Next Page
Loading...
Need help?
General
