7
2. OPERATING THE JABLOTRON 100
+
SYSTEM
Users can authorize themselves by entering their
assigned codes or using their RFID cards/tags.
Each user can have one code and up to two RFID chips
(cards or tags).
Recommended contactless chips: JABLOTRON 100
+
, Oasis or other third-party chips compatible with
125 kHz EM. If higher security is required the alarm system can be set up to use confirmed authorization
using RFID chips and codes (optional).
If the users want to control multiple segments simultaneously, they must authorize themselves and then
press segments of the particular sections subsequently. This way the users can for example set the house
and unset the garage within one single authorization.
If the “Code with a prefix” parameter is enabled, the keypad authorization code can consist
of up to eleven digits: a prefix (one to three digits), an asterisk * (which separates the prefix and main code),
and a 4,6 or 8-digit code depending on configuration (for example: 123*12345678, or 1*12345678). All users
can change their own codes which follow the prefix. The code can be changed from the keypad with the
LCD display, the J-Link software or MyJABLOTRON app.
If the “Code with a prefix” parameter is enabled, the users can be allowed to change their code.
If the “Code with a prefix” parameter is disabled, the codes can be changed only by the Administrator.
2.1.2 KEYPAD CODE AUTHORIZATION
Authorization with a user code is done by typing a valid code into a keypad or with an RFID tag.
It is possible to use 4, 6 or 8-digit codes in the system.
The system can be configured to be used with prefix codes or without them (default settings). For alarm
systems with a higher number of users the prefix can be enabled. To change this option please contact
the service technician of your alarm system.
Code without a prefix: cccc
where:
cccc is a 4, 6 or 8-digit code, allowed codes are from 0000 to 99999999
Default control panel code Administrator: 1234; 123456; 12345678;
Code with a prefix: nnn*cccc
here:
nnn is the prefix, which is the number of the user’s position (position 0 to 600)
* is a separator (key *)
cccc is a 4, 6 or 8-digit code, allowed codes are from 0000 to 99999999
Default control panel code Administrator: 1*1234; 1*123456; 1*12345678;
WARNING: The main Administrator code starts with the prefix 1
The main Service code starts with the prefix 0
To change the code type please contact the service technician of your alarm system.
To Next Page
Loading...
Need help?
General
