Jackson DISHSTAR HT-E - Page 29

07610-004-43-79-Q
22
To access programming mode, machine should be on and not in cycle.
Programming buttons (Up-arrow, Down-arrow, and Select) are hidden on display
and are shown below outlined with red dots.
1. Press and hold Up-arrow and Down-arrow buttons until “Setup” ashes (2–3
seconds).
2. Display will then change to “Version” and show rmware versions of the I/O
module and display.
3. Use Up-arrow button to cycle through categories (will be ashing).
• Language • Wash O󰀨set
• Temperature Scale • Rinse O󰀨set
• Wash Temperature • Boost O󰀨set
• Boost Temperature • Spare O󰀨set
4. Press Select button to choose category to change.
• Regardless of category, Steps 5–7 remain the same.
5. Use Up-arrow button to change options (will be ashing). Numerical options are
shown in top window.
6. Press Select button to accept changes.
7. Press Delime button to exit.
USER SETUP
SETUP
LANGUAGE
LANGUAGE
ENGLISH
TROUBLESHOOTING
PROGRAMMING
A transparent guide to
locating the programming
buttons is included with
machine, behind the kick
panel. Lay the guide over
the display and press
where indicated.