Jackson DISHSTAR HT-E - Troubleshooting; Programming and Setup

21
07610-004-43-79-Q
MODEL
CONFIRMATION
To access programming mode, machine should be on and not in cycle.
The machine's program number must be correct to ensure machine works properly.
To conrm program number:
1. Press and hold I and III buttons until “Program” ashes (2–3 seconds).
2. Conrm bottom display shows “8.” If not, contact a qualied service agency.
3. Press Delime button to exit.
PROGRAM
PROGRAM
8
READY
CYCLE 1
150 F
TROUBLESHOOTING
PROGRAMMING