en-22
SPECIFICATIONS 4
4.7 CUTTING UNIT SPECIFICATION_________________________________________
NOTE: These cutting units are made to cut grass of maximum height 100 mm down to the available
height of cut range.
4.8 CUTTING PERFORMANCE _____________________________________________
405: 4.32 hectares/hr. at 12 km/hr.
305: 3.17 hectares/hr at 12 km/h
250: 2.7 hectares/hr at 12 km/h
(10% allowance is included for normal overlaps and turning at the end of each cut
4.9 RECOMMENDED LUBRICANTS _________________________________________
Grease:
For rear axle: K NATE (RJL No. 4213860), or equivalent to MIL-G-23549C, MIL-G-2345C, DIN 51 825,
DIN 51 818
All other applications: Shell Darina R2 lithium based grease or equivalent.
4.10 ACCESSORIES ______________________________________________________
AIR SUSPENSION SEAT KIT
Fairway 7K Fairway 11K
Construction Welded pressed steel construction
Reel Length 660 mm 660 mm
Number of Knives 7 11
Reel Diameter (New) 165 mm 165 mm
Minimum Reel Diameter (Before Replacement) 148 mm 148 mm
Head Height of Cut 12 mm - 47 mm
Rear Roll 75mm Diameter
Height of Cut Adjustment
Threaded screw system front and rear and three-position
course adjustment on rear roll
Transmission
By direct drive through splined hydraulic motor to splined
reel.
Maximum Reel Speed at Maximum Engine rpm 1200 rpm
To Next Page
Loading...
Need help?
General
