Jacobsen Fairway 305 JGPP305 User Manual

en-57
8 MAINTENANCE & LUBRICATION
8.1 MAINTENANCE & LUBRICATION CHARTS ________________________________
Observe the following for service and maintenance.
The lubricating oil change intervals listed in the table below are for classes CF, CE & CD lubricating oils of API
classification with a low sulphur fuel in use. If a CF-4 or CG-4 lubricating oil is used with a high-sulphur fuel,
change the lubricating oil at shorter intervals than recommended in the table above depending on the operating
condition.
MACHINE MAINTENANCE CHART
Interval Item Section
First 50 hours
 Change Hydraulic Charge Filter Element
8.5
Each day
10 hours
 Check Safety Interlock System.
 Check Hydraulic Fluid Level
 Check Tyre Pressure
 Check Engine Bay for Dirt
7.2
8.5
4.2
8.10
Each week
Every 50 hours
 Check for Loose Components.
 Check for Hydraulic Leaks.
8.10
8.10
End of season
Every 1000
hours
 Check Battery Condition.
 Change Hydraulic Oil and Filter
8.9
8.5
Lubricate all Grease fittings each week
A = Lift Arm Pivot, B =Cutting Unit Pivot, C = Cutting Unit Bearing Housing, D = Steering Ram
Ball Joint, (see the diagram)
FLUID REQUIREMENTS
Quantity Type
Engine Oil (with filter) 6.4 litres 10W 30
Hydraulic Oil (with filter) 37.9 litres Total Equivis ZS 46
Radiator Coolant 6.8 litres 50% Anti-Freeze
Fuel (Fairway 250) 45.4 litres No 2-D (ASTM D975) Diesel
Fuel (Fairway 305) 45.4 litres No 2-D (ASTM D975) Diesel
Fuel (Fairway 405) 45.4 litres No 2-D (ASTM D975) Diesel

Jacobsen Fairway 305 JGPP305 Specifications

General

Brand	Jacobsen
Model	Fairway 305 JGPP305
Category	Lawn Mower
Language	English