Jacto ARBUS 400 - Cautions During Component Assembly

1-18
1
ARBUS 400
PRECAUTIONS
Cautions during component assembly
Warning for adjusting and connecting PTO shaft to the tractor
• Refer to the tractor user manual before
performing this operation.
• Turn off the tractor diesel engine, apply
the parking brake and remove the start-
ing key from the contact keyhole before
coupling the PTO shaft to the tractor PTO.
• Try to couple the PTO shaft to the tractor
PTO. If necessary to adjust the PTO shaft
length, use the PPEs specific to this oper-
ation such as: goggles, gloves, boots, etc.
• When coupling the PTO shaft to the trac-
tor, make sure that the safety pin is se-
curely locked.
• Directions on how to properly adjust
the PTO shaft length will be described in
chapter 2 “ASSEMBLY” of this manual.
• After length adjustment, clean and lu-
bricate the PTO shaft components. Wear
safety gloves for this operation too.
• Never use a PTO shaft not fitted with
shroud.
• The PTO shaft will be adjusted to its spe-
cific use on the Jacto PH 400 equipment.
Use of the PTO shaft on any other equip-
ment is not recommended.
• Do not perform adaptations for reutiliza-
tion of the PTO shaft.
• Fasten the PTO shaft covering safety chain
to the tractor; that chain will prevent the
PTO shaft covering from turning together
with the PTO shaft.
• Before actuating the tractor PTO, fill the
main reservoir.