EasyManuals Logo
Home>Jacuzzi>Hot Tub>Flow

Jacuzzi Flow User Manual

Jacuzzi Flow
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
23
XOperation of the ClearRay™ system is automatic and is de-
pendent upon activation of the circulation pump .
QHydromassage activation
XPress the key once to activate the pump: the relative LED
will light up.
Press the key a second time, the pump will turn o (LED o).
NOTES
If the pump is activated via the button, it will automatically shut
o after 20 minutes unless turned o earlier by the user.
QUnderwater spotlight (multicoloured light)
XPress the key
to activate the spotlight located on the wall
of the tub (the LED comes on).
XThe spotlight will stay on for three hours, but it can be turned
o before that by pressing the key again. Refer to the user’s man-
ual for the operation of the various sequences of colours.
Abnormal operating conditions
- alarm signals -
Alarms are indicated on the display, with the corresponding error code.
You will continue to see the code if the alarm condition persists.
XSignals on display
- possible solution
XLL
the level sensor (where present) identies a low water level. The
term “LL” will appear on the display.
- Rell the water level.
XHIExcessive water temperature
DO NOT ENTER THE WATER
The water temperature has reached or exceeded 44 °C . It is not pos-
sible to activate any function.
- If present, remove cover from spa.
- If the excessive temperature increase is due to sunlight, add
cold water to the spa.
When the temperature has dropped to below 43 °C, the spa should
re-activate automatically. If it does not, disconnect the power sup-
ply and contact an authorized Jacuzzi ® service centre.
XFrWater temperature is too low.
The tub water temperature has fallen below 9 °C. However, all func-
tions remain active.
- Activate the heater.
When the temperature exceeds 10 °C, the error message disappears.
XrPFDefective temperature probe
DO NOT ENTER THE WATER
It is not possible to activate any function.
- Check that the temperature probe is working, or replace it.
4
pump
spotlight
viewing and adjusting temperature,
parameters, functions
Temperature adjustment LED
heater LED
ltering LED
Spotlight operation LED
Pump operation LED

Table of Contents

Other manuals for Jacuzzi Flow

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi Flow and is the answer not in the manual?

Jacuzzi Flow Specifications

General IconGeneral
BrandJacuzzi
ModelFlow
CategoryHot Tub
LanguageEnglish

Related product manuals