24
WARNINGS
Make sure that all users know how to use the spa safely.
How frequently you should check water quality depends on
how frequently the spa is used.
Ensure that the chemicals used are suitable for use in spas;
chemicals designed for swimming pools must not be used
as treatment of water in swimming pools and spas is very
dierent.
CAUTION
Only the load-bearing covers are designed to support
weights (max. 200kg), but they must not be subjected to
violent, sudden stresses (jumping, etc.).
Do not sit, walk, or lie on other types of covers (non-load
bearing). Do not deposit objects.
CAUTION
Read and follow all the instructions related to the use and
storage methods for chemical products, keeping strictly
to the manufacturers instructions on the packets.
After adding the chemicals, the ltering system should be
run for at least 30 minutes to ensure complete dilution in the
water.
Never clean the lter when the pump is running. Turn o the
main switch rst.
Never start the pump and heater if the water level is not
above the highest whirlpool nozzles:
Always turn o the main switch when the spa is empty.
With the TEST button, periodically check the eciency of
the circuit breaker installed up the line from the spa.
It is a good rule to empty the spa regularly (about every 4-8 weeks),
in order to ensure a change of water and proceed with tub cleaning.
If you are away for any length of time, it is advisable to empty
the spa, as long periods without carrying out water treatment can
damage the spa.
CAUTION
Before emptying, make sure that the chemical additive
values in the water are within the permitted limits.
If in doubt, contact the local authorities.
DO NOT EMPTY THE WATER INTO A SEPTIC TANK.
To Next Page
Loading...
Need help?
General