A
Andrew MooreJul 27, 2025
What to do if my Jadever Scales show low battery?
- JjacksonstephenJul 27, 2025
If your Jadever Scales display indicates a low battery, recharge the battery. You can continue to use the scale while it's charging.
To Next PageTo Next PageWhat to do if my Jadever Scales show low battery?
If your Jadever Scales display indicates a low battery, recharge the battery. You can continue to use the scale while it's charging.
What to do if Jadever Scales show overload?
If the Jadever Scales show that the weighed articles are overload, do not load items exceeding the maximum tolerance of the scale.
Why does the initial zero point exceed the limit on my Jadever Scales?
If the initial zero point exceeds the acceptable range on your Jadever Scales, first check for and remove any foreign objects on the scale pan. If the issue persists, it may indicate a LOAD CELL failure, requiring replacement or service.
What to do if Jadever Scales display is out of A/D resolution range?
If your Jadever Scales display a reading that is higher or lower than the A/D resolution range, it could indicate an A/D failure, requiring replacement. Alternatively, it could be a LOAD CELL failure, also requiring replacement or service.
What happens if Jadever JCL Scales exceed the display range for accumulated data?
If the accumulated number of weighments, total count, or weight exceeds the display range on your Jadever Scales, you can no longer accumulate further data.
How to fix EEPROM Chksum failure on Jadever JCL?
In case of an EEPROM Chksum failure in Jadever Scales, re-solder the EEPROM or contact our Service.
General
