JADEVER SCALE CO., LTD - www.dongminhphat.com
16 JCL Service Manual - www.cantudong,com
4-8 Function setting
Turn on the power while pressing key G/N/SET; the scale displays CHECK.
Use MR or TARE to step through all the available setting items.
Use G/N/SET to enter the parameter setting.
Then use MR or TARE to set the content values of setting items.
Press M+/SAVE to save the setting and return, or press ZERO/ESC to return without
saving.
Press ZERO/ESC to return normal weighing mode.
Note: Press and hold key SMPL and G/N/SET while powering on the scale. Press the passcode “11” and
press M+/SAVE to enter the advanced parameter setting.
5. Trouble shootings
5-1 Preliminary checks
Is the bubble of the level indicator at the center?
Is the battery electricity capacity ok?
Is power cord connected both with the scale and with the outlet properly?
Is the weighing pan the right one?
Is there anything under the weighing pan?
Is the scale at a flat and steady base?
Are there any vibrating, rotating, and/or reciprocating equipment around?
5-2 Problems and solutions
To Next Page
Loading...
Need help?
General
